(812) 309-78-59
(495) 223-46-76
ASTM B36/B36M-23
Standard Specification for Brass Plate, Sheet, Strip, And Rolled Bar
9 стр.
Действует
Электронный (pdf)Печатное издание
98.28 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
77.150.30 Copper products / Продукция из меди
Сборник (ASTM):
02.01 Copper and Copper Alloys / Медь и сплавы из меди
Описание
Реферат

This specification establishes the requirements brass plates, sheets, strips, and rolled bars made from UNS C21000, C22000, C22600, C23000, C24000, C26000, C26800, C27200, or C28000. Plates are generally available only in the hot-rolled temper. The standard tempers of as hot rolled, rolled, annealed, and annealed-to-temper materials are detailed in this specification as well as in other specifications listed herein. This specification also contains information on the required tensile strengths, Rockwell hardness and grain sizes of the materials. The Rockwell hardness test can be used to test for general conformity to the specification requirements for temper, tensile strength and grain size.

Область применения

1.1 This specification establishes the requirements for brass (copper-zinc alloy) plate, sheet, strip, and rolled bar of the following alloys:

Copper Alloy
UNS No.

Type of Metal

 

 

C21000

Gilding

C22000

Commerical Bronze

C22600

Jewerly Bronze

C23000

Red Brass

C24000

Low Brass

C26000

Cartridge Brass

C26800

Yellow Brass

C27200

…

C28000

Muntz Metal

1.2 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification.

1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Ключевые слова:
brass plate; brass rolled bar; brass sheet; brass strip; UNS No. C21000; UNS No. C22000; UNS No. C22600; UNS No. C23000; UNS No. C24000; UNS No. C26000; UNS No. C26800; UNS No. C27200; UNS No. C28000;