(812) 309-78-59
(495) 223-46-76
ASTM A1039/A1039M-11
Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process
8 стр.
Заменен
Электронный (pdf)Печатное издание
90.48 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
77.140.01 Iron and steel products in general / Продукция из чугуна и стали в целом
Сборник (ASTM):
01.03 Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar / Сталь - Плиты, листы, штрипсы, проволока; сортовой прокат из нержавеющей стали
Тематика:
Steel--Structural, Tubes, Plate, Coated
Описание
Область применения

1.1 This specification covers commercial andstructural steel sheet in coils and cut lengths produced by thetwin-roll casting process.

1.2 The steel sheet is available in the designationslisted in Section 4.

1.3 The material is available in the followingsizes:

Thickness0.027 in. [0.7 mm] to 0.078in. [2.0 mm]
Widthup to 79 in. [2000 mm]

1.4 The values stated in either SI units orinch-pound units are to be regarded separately as standard. Thevalues stated in each system may not be exact equivalents;therefore, each system shall be used independently of the other.Combining values from the two systems may result in non-conformancewith the standard.

Note 1—Adescription of the Twin-Roll Casting Process is included inAppendix X1.

Ключевые слова:
as-cast sheet; carbon steel sheet; commercial steel; high-strength low-alloy steel; hot rolled steel sheet; steel sheet; structural steel; Carbon steel sheet--specifications; High-strength low-alloy (HSLA) steel; Hot-rolled carbon steel; Steel sheet; Twin-roll casting;