(812) 309-78-59
(495) 223-46-76
ASTM A610-79(2009)
Standard Test Methods for Sampling and Testing Ferroalloys for Determination of Size
2 стр.
Заменен
Печатное изданиеЭлектронный (pdf)
84.24 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
77.100 Ferroalloys. Including classification, designation, sampling, chemical analysis, etc. / Ферросплавы. Включая классификацию, обозначение, отбор образцов, химический анализ и т.д.
Сборник (ASTM):
01.02 Ferrous Castings; Ferroalloys / Стальное литье, Ферросплавы
Тематика:
Steel--Structural, Tubes, Plate, Coated
Описание
Реферат

This specification covers standard methods for sampling and testing of various ferroalloys for size analysis. Ferroalloys are classified into lump and crushed or plates sizes. The small-sized samples subject to screen testing shall be taken from the lot sample by riffling, and larger sized samples by mixing and quartering. Sizing of lumps shall be done by visual examination. Crushed or plates materials shall be subjected to sieving by using either manually driven or mechanically driven screen vibrators to divide samples into several size fractions.

Область применения

1.1 These test methods cover procedures for the sampling and testing of the various ferroalloys for sizing, either before or after shipment from the plants of the manufacturers.

1.2 They are designed to give results representative of each lot that will be comparable with the manufacturer's certified analysis for the same lot.

1.3 The purchaser may use any sampling procedure he desires, but the results obtained on such samples shall not be a basis for complaint or rejection, unless the procedure followed is of an accuracy equivalent to that prescribed in these test methods.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4.1 ExceptionThe SI units that correspond to mesh sizes in Table 1 are to be regarded as standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
crushed; ferroalloys; lump; plates; sampling; sieving; size; sizing; Cast iron (testing); Ferroalloys; Sampling ferrous alloys; Size/size distribution analysis; Stainless steel alloying additives