(812) 309-78-59
(495) 223-46-76
ASTM A793-96(2014)
Standard Specification for Rolled Floor Plate, Stainless Steel (Withdrawn 2023)
4 стр.
Отменен
Электронный (pdf)Печатное издание
93.60 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
77.140.20 Stainless. Including alloyed steels, corrosion-resistant steels, heat-resisting steels, etc. / Высококачественные стали77.140.50 Flat. Including plate, sheet and strip / Стальной листовой прокат и полуфабрикаты. Включая плиты, листы и полосы
Сборник (ASTM):
01.03 Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar / Сталь - Плиты, листы, штрипсы, проволока; сортовой прокат из нержавеющей стали
Тематика:
Steel--Structural, Tubes, Plate, Coated
Описание
Причина отменыThis specification covered stainless steel floor plates 1/2 in. and under for use in galley spaces, washrooms, engine rooms, and machinery spaces, and for ladder treads, gun platforms, and deck treads. For these uses, Patterns A, B, and C were considered interchangeable.

Formerly under the jurisdiction of Committee A01 on Steel, Stainless Steel and Related Alloys, this specification was withdrawn in February 2023 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

Реферат

This specification covers the standard for stainless steel floor plates for use in galley spaces, washrooms, engine rooms, and machinery spaces, and for ladder treads, gun platforms, and deck treads. Several steel grades like Type 304, 304L, 316, 316L used as floor plate material shall conform to the chemical composition requirements in carbon, manganese, phosphorus, sulfur, silicon, nitrogen, nickel, chromium, and molybdenum as determined by heat analysis. Annealing shall be the last heat treatment to which the material is subjected. The stainless steel floor plate shall be in patterns with uniform pitch from center to center, angular figures shall be arranged such that they are in angular position from a vertical or horizontal line and shall have a raised figure. Mechanical properties shall be tested by two longitudinal cold bend tests and the raised figure shall not fracture nor develop cracks or flaws on the materials. Magnetic permeability test shall also be performed on the plates and shall meet the specified magnetic permeability indicator. Floor plates of stainless steel shall be uniform in quality and condition, and free of injurious defects that may detrimentally affect the suitability for the service for which they are intended.

Область применения

1.1 This specification covers stainless steel floor plates 1/2 in. and under for use in galley spaces, washrooms, engine rooms, and machinery spaces, and for ladder treads, gun platforms, and deck treads. For these uses, Patterns A, B, and C are considered interchangeable (see Fig. 1, Fig. 2, and Fig. 3).

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.