(812) 309-78-59
(495) 223-46-76
ASTM A794/A794M-12
Standard Specification for Commercial Steel (CS), Sheet, Carbon (0.16 % Maximum to 0.25 % Maximum), Cold-Rolled
3 стр.
Заменен
Электронный (pdf)Печатное издание
78.00 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
77.140.50 Flat. Including plate, sheet and strip / Стальной листовой прокат и полуфабрикаты. Включая плиты, листы и полосы
Сборник (ASTM):
01.03 Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar / Сталь - Плиты, листы, штрипсы, проволока; сортовой прокат из нержавеющей стали
Тематика:
Steel--Structural, Tubes, Plate, Coated
Описание
Реферат

This specification covers standard requirements for cold-rolled commercial steel sheet coils and cut lengths. The cast or heat analysis of the steel shall conform to the chemical requirements for carbon, manganese, phosphorus, and sulfur. Unspecified elements may be present. Limits on additional elements such as copper, nickel, chromium, molybdenum, vanadium, and columbium shall be stated. The material shall also conform to the required bending properties.

Область применения

1.1 This specification covers cold-rolled commercialsteel (CS) sheet in coils and cut lengths, in which the maximum ofthe specified carbon range is over 0.15 and not over 0.25 %, andthe maximum of the specified manganese range is not over 0.90 %.This material is ordered to chemical composition.

1.2 This specification is not applicable to thesteels covered in Specifications A109/A109M and A1008/A1008M.

1.3 The values stated in either SI units orinch-pound units are to be regarded separately as standard. Thevalues stated in each system may not be exact equivalents;therefore, each system shall be used independently of the other.Combining values from the two systems may result in non-conformancewith the standard.

Ключевые слова:
carbon steel sheet; carbon steel strip; cold rolled steel sheet; cold rolled steel strip; steel sheet; steel strip ; Alloy steel tube--specifications; Carbon steel sheet--specifications; Carbon steel tube--specifications; Cold-rolled steel sheet/strip--specifications;