(812) 309-78-59
(495) 223-46-76
ASTM B313/B313M-09
Standard Specification for Aluminum and Aluminum-Alloy Round Welded Tubes (Withdrawn 2018)
10 стр.
Отменен
Электронный (pdf)Печатное издание
96.72 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
77.150.10 Aluminium products / Продукция из алюминия
Сборник (ASTM):
02.02 Aluminum and Magnesium Alloys / Алюминий и магниевые сплавы
Тематика:
Other Nonferrous Metals
Описание
Причина отменыThis specification covers aluminum and aluminum-alloy tubes made from formed sheet and seam welded by continuous methods.

Formerly under the jurisdiction of Committee B07 on Light Metals and Alloys , this specification was withdrawn in January 2018 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

Реферат

This specification covers aluminum and aluminum-alloy tubes made from formed sheet and seam welded by continuous methods. Chemical conformance shall be determined by analyzing samples taken at a time the ingots are poured, or samples taken from the finished or semi-finished product, following conditions set in the specification. The temper of the tubes shall be that of the sheet from which the tubes are formed, and the sheet shall conform to the specified tensile property requirements. The tube shall be subjected to tension, capability, and pressure tests.

Область применения

1.1 This specification covers aluminum and aluminum-alloy tubes made from formed sheet and seam welded by continuous methods.

1.2 Alloy (Note 1) and temper designations are in accordance with ANSI H35.1/H35.1(M). The equivalent Unified Numbering System alloy designations are those of Table 1 preceded by A9, for example, A91100 for aluminum 1100 in accordance with Practice E527.

Note 1—Throughout this specification use of the term alloy in the general sense includes aluminum as well as aluminum alloy.

Note 2—For the requirements for sheet see Specification B209.

1.3 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see A1.2.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4.1 SI UnitsThe SI units are shown either in brackets or in separate tables.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
aluminum alloy; welded tubes; Aluminum alloys (tube)--specifications; Aluminum tube--specifications; UNS A91100 (Wr. alum. alloy)--tube; UNS A93003 (Wr. alum. alloy)--tube; UNS A93004 (Wr. alum. alloy)--tube; UNS A95050 (Wr. alum. alloy)--tube; UNS A95052 (Wr. alum. alloy)--tube; UNS A95086 (Wr. alum. alloy)--tube; UNS A95154 (Wr. alum. alloy)--tube; UNS A96061 (Wr. alum. alloy)--tube; UNS A97072 (Wr. alum. alloy)--tube