(812) 309-78-59
(495) 223-46-76
ASTM C1336-96(2014)
Standard Practice for Fabricating Non-Oxide Ceramic Reference Specimens Containing Seeded Inclusions (Withdrawn 2018)
3 стр.
Отменен
Электронный (pdf)Печатное издание
84.24 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
81.060.01 Ceramics in general / Керамика в целом
Сборник (ASTM):
15.01 Refractories, Activated Carbon; Advanced Ceramics / Огнеупорные материалы; Активированный уголь, Высококачественная керамика
Тематика:
Glass, Ceramics
Описание
Причина отменыThis practice covered a procedure for fabricating both green and sintered test samples of silicon carbide and silicon nitride containing inclusions.

Formerly under the jurisdiction of Committee C28 on Advanced Ceramics, this practice was withdrawn in October 2018. This standard is being withdrawn without replacement due to its limited use by industry.

Значение и использование

4.1 This practice describes a method of fabrication of known discontinuities in a ceramic specimen. Such specimens are needed and used in nondestructive examination to demonstrate sensitivity and resolution and to assist in establishing proper examination parameters.

Область применения

1.1 This practice covers a procedure for fabricating both green and sintered test samples of silicon carbide and silicon nitride containing inclusions. These samples can be used to determine the sensitivity and detection capability of a nondestructive examination (NDE) method.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
advanced ceramics; non-oxide ceramics