(812) 309-78-59
(495) 223-46-76
ASTM D3154-00
Standard Test Method for Average Velocity in a Duct (Pitot Tube Method)
11 стр.
Заменен
Электронный (pdf)Печатное издание
104.52 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
17.120.20 Flow. Including hydrometric determinations / Поток в открытых каналах
Сборник (ASTM):
11.07 Air Quality / Атмосферный анализ
Тематика:
Atmospheric Analysis
Описание
Область применения

1.1 This test method describes measurement of the average velocity of a gas stream for the purpose of determining gas flow in a stack, duct, or flue. Although technically complex, it is generally considered the most accurate and often the only practical test method for taking velocity measurements.

1.2 This test method is suitable for measuring gas velocities above 3 m/s (10 ft/s).

1.3 This test method provides procedures for determining stack gas composition and moisture content.

1.4 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.

1.5 This test method is applicable to conditions where steady-state flow occurs, and for constant fluid conditions. If these conditions are not meant, other methods must be used.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
stack gas velocity; pitot traverse; pitot tube; Staubscheibe pitot tube; Type S pitot tube; Orsat; Orsat analyzer; Method 1; Method 2; Method 3; Method 4; stack gas moisture; stack gas molecular weight; stack gas density