(812) 309-78-59
(495) 223-46-76
ASTM D3312-04(2013)
Standard Test Method for Percent Reactive Monomer in Solventless Varnishes
2 стр.
Заменен
Печатное изданиеЭлектронный (pdf)
84.24 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
87.040 Paints. Including coating powders, paint coatings and protective paint systems / Краски и лаки. Включая порошки для нанесения покрытий, лакокрасочные покрытия и системы защитной окраски
Сборник (ASTM):
10.02 Electrical Insulation (II): D2519–latest / Электрическая изоляция (II): с D2518 и далее
Тематика:
Electrical Insulating Materials
Описание
Значение и использование

4.1 The percent of reactive monomer in solventless varnishes will affect the viscosity, the handling, and the processing properties of the uncured resin. The percent of reactive monomer will possibly affect the degree of hardness and shrinkage which in turn will affect the physical and electrical properties of the cured resin.

Область применения

1.1 This test method covers the determination of the percent of volatile reactive monomer having a vapor pressure exceeding 13.3 Pa (0.1 Torr) at 25°C in an uncatalyzed solventless varnish. Experience has shown this method does not accurately determine percent reactive monomer when the vapor pressure is less than 13.3 Pa (0.1 Torr).

1.2 The values stated in SI units are the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precaution, see Section 5.

Note 1There is no similar or equivalent ISO/IEC standard.
Ключевые слова:
monomer (See reactive monomer); reactive monomer; reactive monomer, ;%; solventless varnish; varnish