(812) 309-78-59
(495) 223-46-76
ASTM D3930-08(2015)
Standard Specification for Adhesives for Wood-Based Materials for Construction of Manufactured Homes
19 стр.
Заменен
Печатное изданиеЭлектронный (pdf)
118.56 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
83.180 Adhesives. Including adhesive tapes / Клеи. Включая клейкие ленты
Сборник (ASTM):
15.06 Adhesives / Адгезивы
Тематика:
Adhesives
Описание
Реферат

This specification provides the means to measure and evaluate the performance of adhesives for structural or semistructural bonding of wood-to-wood in manufactured homes. Wood as used in this specification includes lumber, plywood, particleboard, gypsum board, and all materials having woodbased surfaces at the bondline. The adhesives can be classified according to resistance to deformation: Group A or structural, and Group B or semistructural. Also, the adhesives may be designated into three types, according to their recommended use based on their resistance to water and water vapor: Type 1 for interior and exterior use, Type 2 for weather-protected interior use, and Type 3 for interior use only. Different tests shall be performed in order to determine the following properties of adhesives: shear strength, gap-filling ability, total deformation resistance, moisture and temperature limitation during fabrication, high-temperature resistance, low-temperature resistance, moisture resistance, aging, oxidation resistance, and mold resistance.

Область применения

1.1 This specification provides the means to measure and evaluate the performance of adhesives for structural or semi-structural bonding of wood-to-wood in manufactured homes. Wood as used in this specification includes lumber, plywood, particleboard, gypsum board, and all materials having wood-based surfaces at the bondline. This specification does not cover other adhesives used in manufactured homes such as adhesives for carpet, floor tile, ceramic fixtures, plastic laminates, trim and millwork, and similar nonstructural applications.

1.1.1 The performance of the adhesives is measured in the following tests:

Number

Test

Section

 1

Low Temperature

16

 2

Dry Lumber

17

 3

Gap-Filling

18

 4

High Temperature

19

 5

Type 3 Qualification

20

 6

Type 2 Qualification

21

 7

Aging, Film Oxidation

22

 8

Aging, Bond Oxidation

23

 9

Resistance to Deformation, Creep

24

10

Mold

25

11

Type 1 Qualification

26

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
adhesive; creep; durability; gap-filling; moisture resistance; oxidation; shear strength;