(812) 309-78-59
(495) 223-46-76
ASTM D3982-08
Standard Specification for Contact Molded Fiberglass (Glass Fiber Reinforced Thermosetting Resin) Ducts
8 стр.
Заменен
Электронный (pdf)Печатное издание
96.72 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
83.120 Reinforced plastics / Армированные пластмассы
Сборник (ASTM):
08.03 Plastics (III): D5117 – latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products / Пластмасса (III): D5117 – и далее; Армированные пластиковые трубопроводные системы и химическое оборудование; Пластмассовые строительные изделия
Тематика:
Plastics
Описание
Реферат

This specification covers the material and design requirements, and fabrication of ducts and hoods made of "fiberglass" (glass fiber reinforced thermosetting resin) consisting of a polyester, vinyl ester, or other qualified resin-matrix systems with fiber reinforcement manufactured by contact molding, intended for use in handling corrosive fumes and process gases. Special attention is given to equipment that operates at specified temperatures with regard to strength and corrosion resistance. This specification does not address the selection of resins and reinforcements for specific chemical environments.

Область применения

1.1 This specification covers ducts fabricated by contact molding intended for use in handling corrosive fumes and process gases. Special attention is given to equipment that operates at temperatures over 180°F (82.2°C) with regard to strength and corrosion resistance.

1.2 The material of construction shall be fiberglass consisting of a polyester, vinyl ester, or other qualified resin-matrix systems with fiber reinforcement in accordance with Specification C 582.

1.3 This specification is not intended to cover selection of resins and reinforcements for specific chemical environments.

1.4 This specification covers ducts up to a design pressure of ±5 psig (34.5 Pa).

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this standard..

Ключевые слова:
chemical resistance; contact molding; ducts; flanges; polyester resin; reinforced plastic; Custom contact-pressure-molded plastics; Glass-fiber-reinforced (GRP) plastics--specifications; Hoods and covers; Laboratory apparatus--specifications; Plastic pipe/tubing/fittings--specifications; Plastics--specifications; Reinforced thermosetting plastics (RTP)--specifications; Resins--specifications