(812) 309-78-59
(495) 223-46-76
ASTM D4315-94(2017)
Standard Test Methods for Rubber Compounding Material—;Zinc Oxide
3 стр.
Заменен
Электронный (pdf)Печатное издание
87.36 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
83.040.20 Rubber. Including carbon black, kaolin clay, etc. / Ингредиенты резиновой смеси. Включая углеродную сажу, каолин и т.д.
Сборник (ASTM):
09.01 Rubber, Natural and Synthetic –– General Test Methods; Carbon Black / Каучук, Натуральный и Синтетический - Общие методы испытаний, Технический углерод
Тематика:
Rubber
Описание
Значение и использование

3.1 These test methods may be used for quality control of zinc oxide used as a compounding material and for research and development studies where zinc oxide is used in a rubber mix.

Область применения

1.1 These test methods cover chemical and physical tests for zinc oxide that are considered to be important to its use in rubber compounding.

1.2 The tests appear in the following order:

  Test

Section

 

Zinc Oxide

5

Lead and Cadmium

6

Sulfur

7

Heat Loss

8

Surface Area

9

Sieve Residue

10

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use For specific precautions, see 5.2.

Ключевые слова:
chemical and physical tests for zinc oxide; heat loss; lead and cadmium in zinc oxide; sieve residue; sulfur in zinc oxide; surface area; zinc oxide; zinc oxide percent;