Причина отмены

This test method provides for the determination of benzene, toluene, C8, C9 and heavier aromatics, and total aromatics in finished motor gasoline. It is also applicable to gasoline blending components.

Formerly under the jurisdiction of Committee D02 on Petroleum Products and Lubricants, this test method was withdrawn in May 2004 and replaced by Test Method D 5580 on the Determination of Benzene, Toluene, Ethylbenzene, p/m-Xylene, o-Xylene, C9 and Heavier Aromatics, and Total Aromatics in Finished Gasoline by Gas Chromatography.

For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards volume information, refer to the standard's Document Summary page on the ASTM website.

Область применения

1.1 This test method provides for the determination of benzene, toluene, C , C and heavier aromatics, and total aromatics in finished motor gasoline. It is also applicable to gasoline blending components.

Note 1-For analysis of gasolines for benzene and toluene, solely, Test Method D3606 can be used.

1.2 This test method is applicable to the following concentration ranges, in liquid volume percent, for the individual aromatics listed above: benzene, 0.1 to 5; toluene, 1 to 20; C , 3 to 25; C and heavier, 5 to 30, and total aromatics, 10 to 80.

1.3 It has not been determined whether this test method is applicable to gasoline containing oxygenates; for example, ethers and alcohols.

1.4 Results are reported to the nearest 0.1% by liquid volume.

1.5 The values stated in SI units are to be regarded as the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Sections 6.1 through 6.8 and 7.1.