(812) 309-78-59
(495) 223-46-76
ASTM D619-14
Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation
8 стр.
Заменен
Электронный (pdf)Печатное издание
96.72 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
29.035.10 Paper and board insulating materials / Бумажные и картонные изоляционные материалы
Сборник (ASTM):
10.01 Electrical Insulation (I): D69–D2484 / Электрическая изоляция (I): D69-D2484
Тематика:
Electrical Insulating Materials
Описание
Реферат

These test methods details the standard procedures for testing certain properties of vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation. Arc resistance, ash content, bond strength (ply adhesion), bursting strength, compressive strength, conditioning, density, dielectric strength, dimensional measurements, flammability, flexural strength, silica content, tearing strength, tensile strength, thickness (for sheets), resistance to impact, Rockwell hardness, volatile matter content, water absorption, and zinc chloride content are among the properties that these test methods shall be able to examine.

Область применения

1.1 These test methods cover the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.

1.2 The procedures appear in the following sections:

Procedure   

Section

   Arc resistance

23

   Ash

6

   Bond strength (ply adhesion)

16

   Bursting strength

14

   Compressive strength

12, 25, 30

   Conditioning

4

   Density

17, 26, 32

   Dielectric strength

18, 27

   Dimensional measurements

28, 33

   Flammability

22

   Flexural strength

13, 31

   Silica

7

   Tearing strength

11

   Tensile strength

10, 24, 29

   Thickness (sheets)

20

   Resistance to impact

15

   Rockwell hardness

19

   Volatile matter

8

   Water absorption

5

   Zinc chloride

9

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 7.3, 22.1, 22.2.

Note 1: The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures. Conduct comparative tests if necessary before directly comparing results of tests using the different procedures.

Ключевые слова:
arc resistance; ash content; bond strength; bursting strength; compressive strength; density; dielectric strength; flame resistance; flexural strength; impact resistance; inside diameter; outside diameter; ply adhesion; rigid rods; rigid sheets; rigid tubes; Rockwell hardness; silica content; tear resistance (internal); tensile strength; thickness; volatile content; vulcanized fibre; wall thickness; water absorption; zinc chloride content;