(812) 309-78-59
(495) 223-46-76
ASTM D6248-98(2012)
Standard Test Method for Vinyl and Trans Unsaturation in Polyethylene by Infrared Spectrophotometry
3 стр.
Электронный (pdf)Печатное издание
54.60 $ (включая НДС 20%)
83.080.20 Thermoplastic materials / Термопластические материалы
Сборник (ASTM):
08.03 Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products / Пластмасса (III): с D5117 и далее
Значение и использование

There are three types of olefinic groups present in sufficient concentrations to warrant consideration, one or more of that can normally be found in any polyethylene. The three types are trans-vinylene, R-CH=CH-R, sometimes referred to as trans-internal unsaturation; vinylidene or pendent methylene, RRC-CH2; and vinyl unsaturation, R-CH=CH2, also referred to as terminal unsaturation.

The type and quantity of these groups can influence the chemical and physical properties of the resin. Information concerning their presence can also be used to characterize or identify unknown resins or blends of resins.

Additives can interfere with unsaturation measurements. The use is cautioned to determine which additives are present and if there any absorbance bands caused by additive presence that overlap or interfere with unsaturation absorbance bands used in this test method in the range of 1050 to 850 cm1. If overlapping bands occur, the method is not applicable.

Interference fringes resulting from smooth sample surfaces can cause measurement errors. This test method requires the use of aluminum foil in the compression molding of samples to provide an adequately rough surface to minimize interference fringes.

Область применения

1.1 This test method covers most types ofpolyethylene, those ethylene plastics consisting of ethylene andα-olefin comonomers longer thanpropylene, and blends of the above in any ratio.

1.2 The values stated in SI units are to be regardedas the standard.

1.3 This standard does notpurport to address all of the safety concerns, if any, associatedwith its use. It is the responsibility of the user of this standardto establish appropriate safety and health practices and determinethe applicability of regulatory limitations prior to use. Specific hazards statements are given in Section8.

Note1—There is no known ISO equivalent for this standard.

Ключевые слова:
FTIR; infrared spectrophotometry; polyethylene; trans-vinylene unsaturation; vinyl unsaturation;