(812) 309-78-59
(495) 223-46-76
ASTM D6536/D6536M-00(2010)e1
Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser
2 стр.
Заменен
Печатное изданиеЭлектронный (pdf)
84.24 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
55.130 Aerosol containers / Аэрозольная тара
Сборник (ASTM):
15.10 Packaging; Primary Barrier Packaging; Cannabis / Упаковка; Первичная барьерная упаковка; Каннабис
Тематика:
Paper & Packaging
Описание
Значение и использование

This test method is to be used to measure the length of a specified dip tube from the bottom of the sealing surface to the end of the dip tube in a mechanical pump dispenser.

This test method is to be used to measure the exposed length of a specified dip tube of a mechanical pump dispenser.

Область применения

1.1 This test method covers the measurement technique for a dip tube of a mechanical pump dispenser.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
dip tube length; dip tube measurement; mechanical pump dispenser; Mechanical pump dispensers; Overall dip tube length; Dip tube applications