(812) 309-78-59
(495) 223-46-76
ASTM D668-12
Standard Test Methods of Measuring Dimensions of Rigid Rods and Tubes Used for Electrical Insulation (Withdrawn 2020)
3 стр.
Отменен
Электронный (pdf)Печатное издание
84.24 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
29.035.01 Insulating materials in general / Изоляционные материалы в целом
Сборник (ASTM):
10.01 Electrical Insulation (I): D69–D2484 / Электрическая изоляция (I): D69-D2484
Тематика:
Electrical Insulating Materials
Описание
Причина отменыThese test methods cover the measurement of the dimensions of all rigid rods and tubes used as electrical insulation, the limitations imposed being those of the size range of the more common forms of measuring instruments used.

Formerly under the jurisdiction of Committee D09 on Electrical and Electronic Insulating Materials, these test methods were withdrawn in March 2020. This standard is being withdrawn without replacement because it is no longer being maintained.

Значение и использование

4.1 These test methods are used to measure the dimensions of the rod or tube to determine conformance with specifications on full lengths or cut lengths. The measurements can also be used for manufacturing control, determination of uniformity, dimensional stability, and physical and electrical properties of the rods and tubes.

Область применения

1.1 These test methods cover the measurement of the dimensions of all rigid rods and tubes used as electrical insulation, the limitations imposed being those of the size range of the more common forms of measuring instruments used.

1.2 Where the number of tests to be made or the specifications covering the rod or tube justify its use, it is acceptable to use an accurately calibrated “go-and-no-go” ring gage of suitable size.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
dimensions; rigid rods; rigid tubes; wall thickness; warp