(812) 309-78-59
(495) 223-46-76
ASTM D7113-05
Standard Test Method for Density of Bituminous Paving Mixtures in Place by the Electromagnetic Surface Contact Methods
3 стр.
Заменен
Печатное изданиеЭлектронный (pdf)
81.12 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
93.080.20 Road. Including asphalts, road pavements, etc. / Дорожно-строительные материалы. Включая асфальт, дорожные покрытия и т.д.
Сборник (ASTM):
04.03 Road and Paving Materials; Vehicle–Pavement Systems / Материалы для покрытия и мощения дорог, Дорожно-транспортные системы
Тематика:
Road & Paving
Описание
Значение и использование

The test method described is useful as a rapid, nondestructive technique for determining the in-place density or relative compaction of compacted bituminous mixtures.

The test method can be used to establish the proper rolling effort and pattern to achieve the required density.

The non-destructive nature of the test allows repetitive measurements to be made at a single test location between roller passes or at multiple locations across the mat to monitor changes in density.

The density results obtained by this test method are relative. Device calibration (correlation with other test methods) is required to convert the results obtained using this method to actual density. Section 6 of this test method describes a method that has proven to be acceptable for correlation.

Note 1—The personnel and equipment used in performing this test can be evaluated in accordance with Specification D 3666.

Note 2—Research and evaluation of devices used in this test method has been conducted. Reference is made to Evaluation of Non-Nuclear Gauges to Measure Density of Hot-Mixed Asphalt Pavements, a pooled fund study, Pedro Romero, Ph.D., P.E., July 2002.

Область применения

1.1 This test method covers the procedures for determining the in-place density and relative compaction of bituminous concrete pavement paving mixtures by an electromagnetic surface contact device by measuring changes in the electromagnetic field resulting from the compaction process.

1.2 The equipment referenced in this method is a surface contact device, which must accommodate surface moisture and temperature variation in the range typically encountered in paving applications. This can be accomplished by design parameters that reduce the devices sensitivity to surface moisture and temperature variation or by measurements and algorithms to account for surface moisture and temperature variance in the rolling pattern.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices prior to use.

1.4 The values stated in SI units are to be regarded as the standard.

Ключевые слова:
bituminous-concrete density; density; in-place density; non-nuclear test method, electronic density device