(812) 309-78-59
(495) 223-46-76
ASTM D7257-06(2011)
Standard Test Method for Automated Shelling Two-Piece Child-Resistant Closures That Are Activated by Two Simultaneous Dissimilar Motions (Withdrawn 2018)
4 стр.
Отменен
Электронный (pdf)Печатное издание
84.24 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
43.040.80 Crash. Including airbags, safety belts, traffic accident issues and safety enhancement matters / Защита при авариях и предохранительная система. Включая подушки безопасности, ремни безопасности, вопросы дорожно-транспортных проишествий и вопросы повышения уровня безопасности
Сборник (ASTM):
15.10 Packaging; Primary Barrier Packaging; Cannabis / Упаковка; Первичная барьерная упаковка; Каннабис
Тематика:
Paper & Packaging
Описание
Причина отменыThis test method covered the measurement of the force required to separate (or "shell") the snap-fitted outer cap from the inner cap of Type IA, IB, or IC child-resistant closures.

Formerly under the jurisdiction of Committee F02 on Primary Barrier Packaging, this test method was withdrawn in May 2018. This standard is being withdrawn without replacement due to its limited use by industry.

Значение и использование

This test method of applying force may be used as a standard test to compare the characteristics of a given design of container/child-resistant closure system with a standard or to compare the characteristics of container/child resistant closure systems differing in construction.

It may be used to simulate certain manipulations that may be expected to occur in protocol testing (such as, prying with the teeth, or objects in the room, biting, and pulling with the teeth).

This test may be used to establish performance specifications. Shelling force may vary with cap application torque, bottle design, and other factors. Consequently where precise comparative results are desired, these factors must be carefully controlled.

Область применения

1.1 This test method covers the measurement of the force required to separate (or shell) the snap-fitted outer cap from the inner cap of Type IA, IB, or IC child-resistant closures. See Practice D3475.

1.2 This test method is an alternative to Test Method D3481, a manual test procedure.

1.3 This test method does not measure the force required to separate parts of a child-resistant closure system that were originally screwed-on instead of snapped-on (for example, pull a cap over or through continuous or multi-start threads when the cap was originally screwed on).

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
shelling; two simultaneous dissimilar motions; Type IA child-resistant closure; Type IB child-resistant closure; Type IC child-resistant closure: Child resistance; Shelling; Two simultaneous dissimilar motions; Type IA child-resistant closure; Type IB child-resistant closure; Type IC child-resistant closure