(812) 309-78-59
(495) 223-46-76
ASTM D8199-20
Standard Test Method for Determining the Specific Strength of Hydraulically Applied Fiber Matrix Products for Erosion Control
4 стр.
Действует
Печатное изданиеЭлектронный (pdf)
68.64 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
13.080.99 Other. Including agricultural aspects related to soils and re-use of soil materials / Качество грунта, прочие аспекты. Включая сельскохозяйственные аспекты, относящиеся к грунтам
Сборник (ASTM):
04.09 Soil and Rock (II): D5878 – latest / Грунт и Горные породы (II): с D5878 и далее
Описание
Значение и использование

5.1 Specific strength is a measure of the ability of a fiber matrix product to withstand force applied by a tensile machine and is useful to understand in order to produce quality products. Specific strength is frequently related to the matrix density, fiber quality, fiber length and chemistry and can be used as a measurement for quality assurance or quality control, or both requirements.

5.2 This method may not be applicable to all hydraulically applied fiber matrix products due to variations in product chemistry.

Note 1: The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D3740 are generally considered capable of competent and objective testing/sampling/inspection/etc. Users of this standard are cautioned that compliance with Practice D3740 does not in itself assure reliable results. Reliable results depend on many factors; Practice D3740 provides a means of evaluating some of those factors.

Область применения

1.1 This standard provides a quantitative test method to determine the specific strength of hydraulically applied fiber matrix products using dry and wet preparation methods in a laboratory setting. This method is designed for use as an index test for product quality assurance or quality control, or both to comply with manufacturing requirements. This test method is not indicative of product performance in the field.

1.2 Units—The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only and are not considered standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this standard.

1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026, unless superseded by this test method.

1.3.1 The procedures used to specify how data are collected/recorded and calculated in the standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of these test methods to consider significant digits used in analysis methods for engineering data.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Ключевые слова:
breaking strength; erosion control; hydraulically applied fiber matrix products; specific strength; tensile;