(812) 309-78-59
(495) 223-46-76
ASTM F1141/F1141M-15
Standard Specification for Wall Coverings
3 стр.
Заменен
Печатное изданиеЭлектронный (pdf)
84.24 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
91.180 Interior finishing / Внутренняя отделка
Сборник (ASTM):
15.11 Consumer Products; Business Imaging Products; Vacuum Cleaners / Потребительские товары; Имиджевая бизнес-продукция; Уборочные машины вакуумного действия
Тематика:
Consumer Product Evaluation
Описание
Реферат

This specification covers the performance, quality, packaging, and marking requirements for flexible wall coverings as a finished product. Also included here are wall preparation and covering installation procedures. The manufacturers shall be responsible for thorough testing and inspection under representative field conditions prior to introduction of new finished products on the market.

Область применения

1.1 This specification covers the performance, quality, packaging, and marking characteristics of flexible wall coverings as finished products.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems has the potential to result in non-conformance with the standard.

Ключевые слова:
backing (substrate); bias; bolt; facing; finished product; intermediate layer; lot (batch); pattern match; pattern repeat; protective layer; register; run; seconds; selvage; shading and waste edge; split bolt; wall covering ;