(812) 309-78-59
(495) 223-46-76
ASTM F1141/F1141M-20
Standard Specification for Wall Coverings
3 стр.
Действует
Печатное изданиеЭлектронный (pdf)
71.76 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
91.180 Interior finishing / Внутренняя отделка
Сборник (ASTM):
15.11 Consumer Products; Business Imaging Products; Vacuum Cleaners / Потребительские товары; Имиджевая бизнес-продукция; Уборочные машины вакуумного действия
Описание
Реферат

This specification covers the performance, quality, packaging, and marking requirements for flexible wall coverings as a finished product. Also included here are wall preparation and covering installation procedures. The manufacturers shall be responsible for thorough testing and inspection under representative field conditions prior to introduction of new finished products on the market.

Область применения

1.1 This specification covers the performance, quality, packaging, and marking characteristics of flexible wall coverings as finished products.

1.1.1 Whenever this specification refers to wall coverings, it is intended also to refer to ceiling coverings of the same type.

1.1.2 This specification does not apply to wall coverings intended to be applied to exterior walls.

1.1.3 This specification does not apply to rigid panel products, irrespective of whether or not they include a flexible lining or veneer.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems has the potential to result in non-conformance with the standard.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Ключевые слова:
backing (substrate); bias; bolt; facing; finished product; intermediate layer; lot (batch); pattern match; pattern repeat; protective layer; register; run; seconds; selvage; shading and waste edge; split bolt; wall covering ;