(812) 309-78-59
(495) 223-46-76
ASTM F725-89(1996)
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
4 стр.
Заменен
Печатное изданиеЭлектронный (pdf)
81.12 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
23.040.20 Plastics pipes / Пластмассовые трубы23.040.45 Plastics fittings / Пластмассовые фитинги
Сборник (ASTM):
08.04 Plastic Piping Systems (I): D1598 – F2735 / Пластиковые трубопроводные системы (I): D1598 – F2735
Тематика:
Plastic Pipe
Описание
Область применения

1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.

1.2 This practice is applicable to thermoplastic pipe and fittings.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
Impact testing-plastics; Pipe fittings-plastic (general); Plastic pipe/tubing/fittings-thermoplastic; drafting impact test requirements in thermoplastic pipe/fitting; standards, practice,; Resistance-impact (plastics); thermoplastic pipe/fittings-drafting impact test requirements in; standards, practice