(812) 309-78-59
(495) 223-46-76
ASTM F998-12
Standard Specification for Centrifugal Pump, Shipboard Use
15 стр.
Заменен
Электронный (pdf)Печатное издание
107.64 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
23.080 Pumps / Насосы
Сборник (ASTM):
01.07 Ships and Marine Technology (I): F670 – F1511 / Судоходные и Морские Технологии (I): F670 – F1511
Тематика:
Steel--Structural, Tubes, Plate, Coated
Описание
Реферат

This specification covers the requirements applicable to the design and construction of three classes of centrifugal pump (Class 1, Class 2, and Class 3) for shipboard application. When selecting material combinations, the conditions under which the various materials interact with each other shall be taken into consideration as well as the use of nonmetallic (composite) pump components where the use of that material can benefit the operation and maintenance of the pump. The requirements for the following are detailed: (1) pump design and construction, (2) pump operation (at or near the best efficiency point), (3) motor power ratings, (4) pitch and roll conditions, (5) horizontal pump and driver mounting, (6) vertical pump support, (7) bedplates, (8) pump couplings, (9) guards, (10) pumps with face-mounted motors, (11) shaft alignment, and (12) indication of direction of rotation. Pump design requirements for inlet and outlet connections, casings, radial and thrust bearings, journal and thrust bearings, rolling element bearings, mechanical seals, separate pressure boundary parts, and screw threads are specified. Requirements for paintings and coatings, equipment identification plates, and testing such as hydrostatic, mechanical run, performance, net positive suction head, vibration, and acoustic tests are also specified.

Область применения

1.1 This specification covers the requirements applicable to the design and construction of centrifugal pumps for shipboard application. The three classes of service covered by this specification are as follows:

1.1.1 Class 1Freshwater,

1.1.2 Class 2Seawater, and

1.1.3 Class 3Hydrocarbon pumps (less than 1500 SSU).

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.

Ключевые слова:
bilge and ballast pump; boiler feed pump; centrifugal; centrifugal pump; condensate pump; freshwater pump; hydrocarbon pump; impeller; marine pump; pump; seawater pump