(812) 309-78-59
(495) 223-46-76
ÖNORM EN 1264-2:2009-01
Water based surface embedded heating and cooling systems - Part 2: Floor heating: Prove methods for the determination of the thermal output using calculation and test methods
Заменен
Печатная копияПечатное издание
132.00 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
91.140.10 Central. Including burners and boilers for central heating systems / Системы центрального отопления. Включая горелки и котлы для систем центрального отопления
Описание
This European Standard specifies the boundary conditions and the prove methods for the determination of
the thermal output of hot water floor heating systems as a function of the temperature difference between the
heating medium and the room temperature.
This standard shall be applied to commercial trade and practical engineering if proved and certifiable values
of the thermal output shall be used.
This European Standard applies to heating and cooling systems embedded into the enclosure surfaces of
the room to be heated or to be cooled. This Part of this European Standard applies to hot water floor heating
systems. Applying of Part 5 of this European Standard requires the prior use of this Part of this European
Standard. Part 5 of this European Standard deals with the conversion of the thermal output of floor heating
systems determined in Part 2 into the thermal output of heating surfaces embedded in walls and ceilings as
well as into the thermal output of cooling surfaces embedded in floors, walls and ceilings.
The thermal output is proved by a calculation method (Clause 6) and by a test method (Clause 9). The
calculation method is applicable to systems corresponding to the definitions in EN 1264-1 (type A, type B,
type C, type D). For systems not corresponding to these definitions, the test method shall be used. The
calculation method and the test method are consistent with each other and provide correlating and adequate
prove results.
The prove results, expressed depending on further parameters, are the standard specific thermal output and
the associated standard temperature difference between the heating medium and the room temperature as
well as fields of characteristic curves showing the relationship between the specific thermal output and the
temperature difference between the heating medium and the room.
Diese Europäische Norm legt die Randbedingungen und die Prüfverfahren für die Bestimmung der Wärmeleistung
von Warmwasser-Fußbodenheizsystemen in Abhängigkeit von der Differenz zwischen der Heizmittel-
und der Raumtemperatur fest.
Die vorliegende Norm ist auf den kommerziellen Handel und das praktische Ingenieurwesen anzuwenden,
sofern geprüfte und zertifizierbare Werte für die Wärmeleistung erforderlich sind.
Diese Europäische Norm gilt für Heiz- und Kühlsysteme, die in die Raumumschließungsflächen des zu
heizenden oder zu kühlenden Raumes integriert sind. Der vorliegende Teil dieser Europäischen Norm gilt für
Warmwasser-Fußbodenheizsysteme. Die Anwendung von Teil 5 dieser Europäischen Norm erfordert die
vorherige Anwendung des vorliegenden Teils dieser Europäischen Norm. Teil 5 dieser Europäischen Norm
behandelt die Umrechnung der in Teil 2 bestimmten Wärmeleistung der Fußbodenheizsysteme in die Wärmeleistung
von Heizflächen in Wänden und Decken sowie in die Kühlleistung von Kühlflächen in Fußböden,
Wänden und Decken.
Die Wärmeleistung wird durch ein Berechnungsverfahren (Abschnitt 6) und ein experimentelles Verfahren
(Abschnitt 9) geprüft. Das Berechnungsverfahren ist auf Systeme anwendbar, die den Definitionen nach
EN 1264-1 (Typ A, Typ B, Typ C, Typ D) entsprechen. Bei Systemen, die diesen Definitionen nicht entsprechen,
ist das experimentelle Verfahren anzuwenden. Das Berechnungsverfahren und das experimentelle
Verfahren entsprechen einander und liefern korrelierende, adäquate Prüfergebnisse.
Als Prüfergebnisse werden die spezifische Normwärmeleistung mit der zugehörigen Normdifferenz zwischen
der Heizmittel- und der Raumtemperatur sowie Kennlinienfelder für die Beziehung zwischen der spezifischen
Wärmeleistung und der Differenz zwischen der Heizmittel- und der Raumtemperatur in Abhängigkeit von
weiteren Parametern angegeben
Ключевые слова:
Heizung, Heizungsanlage, Warmwasserheizung, Abbildung, Heizfläche, Wärmestrom, Berechnung, Wärmeleistung, Wärmeleitfähigkeit, Bestimmungsverfahren, Fußbodenheizung, Heizsystem, Kühlsystem, Raumflächenintegration, Prüfverfahren, Bestimmung, Benutzung, Berechnungsmethode, Gleichung, Prüfbericht, Prüfsystem