(812) 309-78-59
(495) 223-46-76
ÖNORM EN 1555-3:2005-10
Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) - Part 3: Fittings (consolidated version)
Отменен
Печатная копияПечатное издание
114.00 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
23.040.45 Plastics fittings / Пластмассовые фитинги91.140.40 Gas. Including gas meters in buildings / Системы газоснабжения
Описание
This part of EN 1555 specifies the characteristics of fusion fittings made from polyethylene (PE) as well as of mechanical
fittings made from PE and other materials for piping systems in the field of the supply of gaseous fuels.
It also specifies the test parameters for the test methods referred to in this standard.
In conjunction with the other parts of EN 1555 (see Foreword), it is applicable to PE fittings, their joints and to joints with
components of PE and other materials intended to be used under the following conditions:
a maximum operating pressure, MOP, up to and including 10 bar 1);
an operating temperature of 20 °C as reference temperature.
NOTE 1 For other operating temperatures, derating coefficients should be used, see EN 1555-5.
EN 1555 covers a range of maximum operating pressures and gives requirements concerning colours and additives.
NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects,
taking into account their particular requirements and any relevant national regulations and installation practices or codes.
This standard is applicable for fittings of the following types:
electrofusion socket fittings;
electrofusion saddle fittings;
spigot end fittings (for butt fusion using heated tools and electrofusion socket fusion);
mechanical fittings.
The fittings can e.g. be in the form of couplers, equal and reduced tees, reducers, bends or caps.
In dieser ÖNORM werden Anforderungen an Formstücke aus Polyethylen (PE) für Schweißverbindungen und an Formstücke aus PE oder anderen Werkstoffen für mechanische Verbindungen festgelegt, die in Rohrleitungssystemen für die Gasversorgung eingesetzt werden. Weiters werden auch die Prüfparameter für die Prüfverfahren festgelegt, auf die in dieser Norm verwiesen wird. Zusammen mit den übrigen Teilen der EN 1555 gilt dieser Teil für Formstücke aus PE, deren Verbindungen untereinander und mit anderen Rohrleitungsteilen aus PE und anderen Werkstoffen, die unter den folgenden Bedingungen für die Gasversorgung vorgesehen sind: a) der maximal zulässige Betriebsdruck MOP beträgt nicht mehr als 10 bar (1 bar = 0,1 MPa); b) es gilt eine Betriebstemperatur von 20 °C als Bezugstemperatur.
Ключевые слова:
Bauwesen, Gasversorgung, Polyethylen, Kunststoff, Rohrleitung, Rohrleitungssystem, Rohr, Begriffe, Terminologie, Werkstoff, Prüfung, Prüfverfahren, Formstück, Berechnung, Eigenschaft, Kennzeichnung, Gasrohr, Gasleitung, Schweißen, Heizwendelschweißen