(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 13920:1996-10
Welding - General tolerances for welded constructions - Dimeensions for lengths and angles - Shape and position (ISO 13920:1996)
Действует
Печатная копияПечатное издание
114.98 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
25.160.01 Welding,. Including welders' qualifications / Сварка, пайка твердым и мягким припоем в целом. Включая квалификацию сварщика
Описание
This European Standard specifies general tolerances for linear and angular dimensions and for shape and position of welded structures in four tolerance classes, these being based on customary workshop accuracy. The main criterion for the selection of a particular tolerance class should be the functionat requirements which are to be met. The applicable tolerances are always those which are stated in the drawing. Instead of specifying individual tolerances the tolerance ciasses according to this standard may be used. General tolerances for linear and angular dimensions and for shape and position as specified in this standard apply for weldments, welding assemblies and welded structures etc. Special provisions may be necessary for complex structures. The specifications given in this standard are based on the principle of independency as specified in ISO 8015, according to which the dimensional and geometrical tolerances apply independently of each other. Manufacturing documentation in which linear and angular dimensions or indications for shape and position are presented without individually indicated tolerances shall be deemed incomplete if there is no, or inadequate, reference to general tolerances. This does not apply to temporary dimensions.
Behandelt sind Allgemeintoleranzen für Längen- und Winkelmaße an Schweißkonstruktionen in vier Toleranzklassen, die auf werkstattüblichen Genauigkeiten basieren. Die Wahl einer bestimmten Toleranzklasse sollte vorrangig nach den funktionellen Forderungen festgelegt werden. Wenn kleinere Toleranzen notwendig oder größere zulässig und wirtschaftlicher sind, müssen sie einzeln angegeben werden. Allgemeintoleranzen für Längen- und Winkelmaße gelten für Schweißteile, Schweißgruppen und Schweißkonstruktionen, wenn in Zeichnungen oder sonstigen Unterlagen, zB Lieferbedingungen, auf diese Norm hingewiesen wird. Bei Längenmaßen von Schweißkonstruktionen, die sich aus mehreren Schweißgruppen zusammensetzen, können Sonderregelungen erforderlich werden. Die Festlegungen in dieser Norm basieren auf dem Unabhängigkeitsprinzip nach ISO 8015, wonach die Maß-, Form- und Lagetoleranzen unabhängig voneinander gelten.
Ключевые слова:
Schweißen, Schweißkonstruktion, Längenmaß, Winkelmaß, Form, Lage, Toleranz, Toleranzklasse, Grenzabmaß, Abbildung, Geradheit, Ebenheit, Parallelität, Prüfung, Allgemeintoleranz