(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 14405-2:2012-03
Geometrical product specifications (GPS) - Dimensional tolerancing - Part 2: Dimensions other than linear sizes (ISO 14405-2:2011)
Заменен
Печатное изданиеПечатная копия
170.35 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
17.040.10 Limits and fits / Допуски и посадки17.040.40 Geometrical Product Specification (GPS) / Геометрические характеристики изделий
Описание
This part of ISO 14405 illustrates the use of geometrical tolerancing for dimensions that are not linear sizes to avoid the ambiguity that the use of plus-minus tolerances on these dimensions causes. Both linear and angular dimensions, except size of features of size are covered. Dimensional tolerancing can be indicated by plus-minus tolerancing or geometrical tolerancing. The ambiguity caused by using plus-minus tolerances for dimensions other than linear sizes (for individual tolerances and general tolerances according to, e.g. ISO 2768-1 and ISO 8062-3) is explained in Annex A.
Dieser Teil von ISO 14405 veranschaulicht die Verwendung der geometrischen Tolerierung für Maße, welche
keine linearen Maße sind, um die Mehrdeutigkeit zu vermeiden, welche die Verwendung von
Plus-Minus-Toleranzen bei diesen Maßen verursacht. Sowohl lineare Maße, als auch Winkelmaße, mit Ausnahme
von Abmaßen von Maßelementen, werden abgedeckt.
Die dimensionelle Tolerierung kann als Plus-Minus-Tolerierung oder als geometrische Tolerierung in die
Zeichnung eingetragen werden.
Die durch die Verwendung der Plus-Minus-Tolerierung für andere als lineare Maße (für Einzeltoleranzen und
Allgemeintoleranzen nach z. B. ISO 2768-1 und ISO 8062-3) verursachte Mehrdeutigkeit ist in Anhang A
erklärt.
Ключевые слова:
geometrische Produktspezifikation,GPS,Dimensionelle Tolerierung,Andere als ineare Maße,geometrische Tolerierung,Begriffe,Terminologie,Zeichnungseintragung,Plus-Minus-Tolerierung