(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 1873-1:1996-05
Plastics - Polypropylene (PP) moulding and extrusion materials - Part 1: Designation system and basis for specifications (ISO 1873-1:1995)
Заменен
Печатная копияПечатное издание
75.00 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
83.080.20 Thermoplastic materials / Термопластические материалы
Описание
This part of ISO 1873 establishes a System of designation for polypropylene (PP) thermoplastic material, which may be used as the basis for specifications. The types of polypropylene plastics are differentiated from each other by a classification System based on
appropriate levels of the designatory properties
a) tensile modulus of elasticity
b) impact strength
c) melt mass-flow rate (MFR)
and on information about basic polymer Parameters, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. This part of ISO 1873 is applicable to all propylene homopolymers and to copolymers of propylene with a content of other 1-olefins of less than 50 % (m/m), as well as blends of polymers containing at least 50 % (dm) of aforementioned polymers. It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc. This part of ISO 1873 does not apply to propylene-based rubber.
In dieser Norm wird ein Bezeichnungssystem für thermoplastische PP-Formmassen festgelegt, das als Grundlage für Spezifikationen dienen kann. PP-Formmasse-Typen werden mit Hilfe eines Einteilungssystems von einander unterschieden, das auf geeigneten Wertebereichen der kennzeichnenden Eigenschaften und Informationen über grundlegende Polymer-Parameter, vorgesehene Anwendung und/oder Verarbeitungsverfahren, wichtige Eigenschaften, Additive, Farbstoffe, Füll- und Verstärkungsstoffe beruht. Diese Norm ist anwendbar für alle PP-Homopolymere, Copolymere des Polypropylens mit einem Massenanteil anderer Olefine von weniger als 50 % und Mischungen von Polymeren bestehend aus mindestens 50 Gew.-% der vorgenannten Polymeren. Die Norm ist nicht anwendbar für Kautschuk auf Basis Polypropylen
Ключевые слова:
Kunststoff,Polypropylen,Formmasse,Bezeichnung,Spezifikation,Thermplast,Bezeichnungssystem,Polymer,Schlagzähigkeit,Schmelze,Symbol,PP