(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 2039-2:1999-12
Plastics - Determination of hardness - Part 2: Rockwell hardness (ISO 2039-2:1987)
Действует
Печатная копияПечатное издание
129.89 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
83.080.01 Plastics in general / Пластмассы в целом
Описание
1 .I This part of IS0 2039 specifies a method for determining
the indentation hardness of plastics by means of the Rockwell
hardness tester using the Rockwell M, L and R hardness scales.
1.2 A Rockwell hardness number is directly related to the indentation
hardness of a plastic material; the higher the
Rockwell hardness number, the harder the material. Due to a
short overlap of Rockwell hardness scales by this procedure,
two different Rockwell hardness numbers of different scales
may be obtained on the same material, both of which may be
technically correct.
1.3 For materials having high creep and recovery, the timefactors
involved in application of the major and minor loads
have a considerable effect on the results of the measurements.
1.4 An alternative method of using the apparatus to give
hardness on the Rockwell-cc hardness scale is specified in the
annex which shows how this scale may be related to the hardness
measurement of IS0 2039-l.
1.1 Dieser Teil von ISO 2039 legt ein Verfahren zur Bestimmung der Eindruckhärte von Kunststoffen mit einer
Rockwellhärteprüfmaschine unter Vennrendung der Rockwellhärteskalen M, L und R fest.
1.2 Der Rockwellhärtewert steht in direktem Zusammenhang mit der Eindruckhärte eines Kunststoffes; je größer der
Rockwell härtewert desto härter der Kunststoff. Wegen einer geringen Überlappung der Rockwellhärteskalen bei diesem
Verfahren können zwei verschiedene Rockwellhärtewerte in verschiedenen Skalen für den gleichen Kunststoff erhalten
werden, wobei beide Werte technisch korrekt sein können.
1.3 Für Kunststoffe mit hoher Kriechdehnung und Rückdehnung haben die Zeitfaktoren bei der Anwendung von
Prüflast und Vorlast einen wesentlichen Einfluß auf die Meßergebnisse.
1.4 Ein alternatives Verfahren der Anwendung der Härtepnifmaschine zur Bestimmung der Rockwellhärte a wird im
Anhang festgelegt, mit dem dargestellt wird, wie diese Skala mit Härtemessungen nach ISO 2039-1 in Zusammenhang
gebracht werden kann.
Ключевые слова:
Kunststoff, Bestimmungsverfahren, Härte, Rockwellhärte, Härteprüfung, Prüfverfahren, Prüfung, Prüfgerät, Prüfbericht, Abbildung