(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 22854:2014-06
Liquid petroleum products - Determination of hydrocarbon types and oxygenates in automotive-motor gasoline and in ethanol (E85) automotive fuel - Multidimensional gas chromatography method (ISO 22854:2014)
Заменен
Печатная копияПечатное издание
100.56 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
75.160.20 Liquid. Including gasoline, diesel, kerosene, etc. / Жидкое топливо75.080 Petroleum products in general / Нефтяные продукты в целом
Описание
This International Standard specifies the gas chromatographic (GC) method for the determination
of saturated, olefinic and aromatic hydrocarbons in automotive motor gasoline and ethanol (E85)
automotive fuel. Additionally, the benzene content, oxygenate compounds and the total oxygen content
can be determined.

This International Standard defines two procedures, A and B.

Procedure A is applicable to automotive motor gasoline with total aromatics of up to 50 % (V/V); total
olefins from about 1,5 % (V/V) up to 30 % (V/V); oxygenates from 0,8 % (V/V) up to 15 % (V/V); total
oxygen from about 1,5 % (V/V) to about 3,7 % (V/V); and benzene of up to 2 % (V/V). The system may
be used for ethers with 5 or more C atoms up to 22 % (V/V) but the precision has not been established
up to this level.

Although this test method may be used to determine higher-olefin contents of up to 50 % (V/V), the
precision for olefins was tested only in the range from about 1,5 % (V/V) to about 30 % (V/V).
Although specifically developed for the analysis of automotive motor gasoline that contains oxygenates,
this test method may also be applied to other hydrocarbon streams having similar boiling ranges, such
as naphthas and reformates.

Procedure B describes the procedure for the analysis of oxygenated groups (ethanol, methanol, ethers,
C3 - C5 alcohols) in ethanol (E85) automotive fuel containing ethanol between 50 % (V/V) and 85 %
(V/V). The gasoline is diluted with an oxygenate-free component to lower the ethanol content to a value
below 20 % (V/V) before the analysis by GC. If the ethanol content is unknown, it is advised to use a
dilution of 4:1 when analysing the sample.
The sample may be fully analysed including hydrocarbons. Precision data for the diluted sample is only
available for the oxygenated groups.
Diese Internationale Norm legt ein Verfahren zur gaschromatographischen Bestimmung (GC) der Gehalte an gesättigten, olefinischen und aromatischen Kohlenwasserstoffen in Kraftstoffen für Kraftfahrzeugmotoren und Ethanolkraftstoff (E85) fest. Zusätzlich können die Gehalte an Benzol und sauerstoffhaltigen Verbindungen sowie der Gesamtsauerstoffgehalt bestimmt werden.

Dieses Dokument legt zwei Verfahren, A und B, fest.

Verfahren A ist anwendbar für Kraftstoffe für Kraftfahrzeugmotoren mit einem Gesamtanteil bis 50 % (V/V) Aromaten, einem Gesamtanteil an Olefinen von etwa 1,5 % (V/V) bis 30 % (V/V), einem Anteil an sauerstoffhaltigen Verbindungen von 0,8 % (V/V) bis 15 % (V/V), einem Gesamtanteil an Sauerstoff von etwa 1,5 % (V/V) bis etwa 3,7 % (V/V) und einem Anteil an Benzol bis zu 2 % (V/V). Das Verfahren kann auch zur Bestimmung von Ethern mit fünf oder mehr Kohlenstoffatomen bis zu Gehalten von 22 % (V/V) eingesetzt werden, jedoch wurden bis zu diesem Gehalt keine Präzisionsdaten ermittelt.

Obwohl dieses Verfahren zur Bestimmung höherer Olefingehalte bis zu 50 % (V/V) angewendet werden kann, wurde die Präzision für Olefine nur im Bereich von etwa 1,5 % (V/V) bis etwa 30 % (V/V) ermittelt.
Obwohl dieses Verfahren speziell für die Analyse von Ottokraftstoffen mit sauerstoffhaltigen Verbindungen entwickelt wurde, darf es auch auf andere Kohlenwasserstoffe mit ähnlichen Siedebereichen, wie z. B. Naphthas und Reformate, angewendet werden.

Verfahren B beschreibt das Verfahren zur Analyse von sauerstoffhaltigen Verbindungen (Ethanol, Methanol, Ether, C3 - C5 Alkohole) in ethanolhaltigen Ottokraftstoffen mit einem Ethanolgehalt zwischen 50 % (V/V) und 85 % (V/V). Dieser Kraftstoff wird mit einer sauerstofffreien Komponente verdünnt, um den Ethanolgehalt vor der GC-Analyse auf einen Wert unter 20 % (V/V) zu senken. Wenn der Ethanolgehalt unbekannt ist, wird empfohlen, eine Verdünnung von 4 : 1 bei der Analyse zu verwenden.
Für die Probe kann auch eine Vollanalyse einschließlich der Kohlenwasserstoffe erfolgen, jedoch sind Präzisionsdaten für die verdünnte Probe nur für die Gruppe der Sauerstoffverbindungen vorhanden.
Ключевые слова:
Erdölprodukt,flüssiges Mineralölerzeugnis,Bestimmung,Kohlenwasserstoffgruppe,Sauerstoffhaltige Verbindung,Kraftstoff,Kraftfahrzeugmotor,Multidimensionales gaschromatographisches Verfahren,Begriffe,Terminologie,Chemikalien,Materialien,Prüfeinrichtung,Berechnung,Angabe der Ergebnisse,Präzision,Prüfbericht