(812) 309-78-59
(495) 223-46-76
ÖNORM EN 10048:1996-11
Hot rolled narrow steel strip - Tolerances on dimensions and shape
Действует
Печатная копияПечатное издание
150.53 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
77.140.50 Flat. Including plate, sheet and strip / Стальной листовой прокат и полуфабрикаты. Включая плиты, листы и полосы
Описание
This European Standard applies to uncoated hot rolled narrow steel strip, of width less than 600 mm, made of the steel grades covered by the following: EURONORMS 85, 86, 89, 96, 132;
European Standards EN 10025, EN 10028-2, EN 10028-3, EN 10083-1, EN 10083-2, EN 10083-3, EN 10088-2, EN 10113-2, EN 10113-3, EN 10137-2, EN 10137-3, EN 10149-2, EN 10149-3, EN 10155, EN 10207 and EN 10208-2; draft European Standards prEN 10028-5, prEN 10028-6 and prEN 10084.
NOTE: This Europeiin Standard may be applied to other types of steels if agreed at the time of ordering.
This European Standard does not apply to hot rolled wide strip and narrow strip (width < 600 mm) obtained by slitting hot rolled wide strip. (The tolerances on shape and dimensions applicable to these products are given in EN 10051.)
Diese Norm gilt für warmgewalzten Bandstahl ohne Überzug in Walzbreiten unter 600 mm aus den Stahlsorten nach den EURONORMEN und Europäischen Normen, die in Abschnitt 1 der Norm angeführt sind. Die Anwendung dieser Norm auf andere Stahlsorten kann bei der Bestellung vereinbart werden. Die Norm gilt nicht für warmgewalztes Breitband und nicht für Warmband (in Breiten unter 600 mm), das durch Längsteilen von warmgewalztem Breitband hergestellt wurde.
Ключевые слова:
Stahl, Bandstahl, warmgewalzt, Formtoleranz, Maschinenbau, Bezeichnung, Abmessung, Abbildung, Grenzabmaß