Каталог стандартов
+7 (495) 223-46-76
+7 (812) 309-78-59
inform@normdocs.ru
API Monogram
Новые стандарты
Touch and interactive displays - Part 1-3: Generic - Overview of pen touch technology
— 64 стр.
Touch and interactive displays - Part 1-3: Generic - Overview of pen touch technology
— 33 стр.
Electrical relays - Tests and measurements - Part 46: Impulse voltage test
— 9 стр.
Electrical and electronic household and office equipment - Measurement of networked standby power of edge equipment
— 40 стр.
Sustainable management of waste electrical and electronic equipment (e-waste)
— 104 стр.
Microgrids - Part 3-5: Technical requirements - Testing for microgrid monitoring, control, and energy management systems
— 34 стр.
Reference conditions and procedures for testing industrial and process measurement transmitters - Part 1: General procedures for all types of transmitters
— 173 стр.
Reference conditions and procedures for testing industrial and process measurement transmitters - Part 1: General procedures for all types of transmitters
— 80 стр.
Замененные стандарты
Touch and interactive displays - Part 1-3: Generic – General introduction to pen touch technology
— 26 стр.
Electrical and electronic household and office equipment - Measurement of networked standby power consumption of edge equipment
— 46 стр.
Reference conditions and procedures for testing industrial and process measurement transmitters - Part 1: General procedures for all types of transmitters
— 176 стр.
Reference conditions and procedures for testing industrial and process measurement transmitters - Part 2: Specific procedures for pressure transmitters
— 49 стр.
Industrial-process control systems - Methods of evaluating the performance of valve positioners with pneumatic outputs
— 83 стр.
Process measurement and control devices - General methods and procedures for evaluating performance - Part 3: Tests for the effects of influence quantities
— 59 стр.
Process measurement and control devices - General methods and procedures for evaluating performance - Part 1: General considerations
— 34 стр.
Process measurement and control devices - General methods and procedures for evaluating performance - Part 2: Tests under reference conditions
— 53 стр.
Отмененные стандарты
Standard Practice for Estimation of Heat Savings by Adding Thermal Insulation to Bare Valves and Flanges (Withdrawn 2026)
— 8 стр.
Steel Castings, Sand, 0.80cr 1.8ni 0.35mo (0.28-0.36c) Annealed
Epoxy Primer Plating Electrodeposition
Diglycidyl Ester Resin
Epoxy Resin, Tetraglycidyl Methylenedianiline (TGMDA), 10,000 to 14,000 Centipoise Viscosity
Steel Bars, Forgins, and Rings, Corrosion Resistant 14cr 13.5co 5.0mo 0.50ni 0.20v Premium Quality, Consumable Electrode Melted
Aluminum Alloy, Forgings, 4.3zn 3.3mg 0.6cu 0.2mn 0.2cr, Solution and Precipitation Heat Treated, Low Residual Stresses
Foam, Flexible Polyurethane (Pur), Open Pore, Polyvinylchloride (Pvc) Coated