(812) 309-78-59
(495) 223-46-76
ASTM C1106-00(2012)
Standard Test Methods for Chemical Resistance and Physical Properties of Carbon Brick (Withdrawn 2021)
6 стр.
Отменен
Электронный (pdf)Печатное издание
96.72 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
81.080 Refractories. Including ceramic refractories / Огнеупоры. Включая огнеупоры из керамики
Сборник (ASTM):
04.05 Chemical–Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete / Химически устойчивые неметаллические материалы; Глазированные керамические трубы; Трубы бетонные; изделия из фиброцемента; Известковые цементные растворы; Монолитный бетон; Сборный бетон
Тематика:
Masonry
Описание
Причина отменыThese test methods are intended for use as short-term tests for evaluating the physical properties of carbon brick and their chemical resistance at various temperatures in immersion service.

Formerly under the jurisdiction of Committee C03 on Chemical-Resistant Nonmetallic Materials, these test methods were withdrawn in January 2021 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

Значение и использование

4.1 The results obtained by these test methods should serve as a guide in, but not as the sole basis for, the selection of a chemical-resistant carbon brick for a particular application. No attempt has been made to incorporate into these test methods all the factors that may affect the performance of carbon brick when subjected to various actual service conditions.

Область применения

1.1 These test methods are intended for use as short-term tests for evaluating the physical properties of carbon brick and their chemical resistance at various temperatures in immersion service. These test methods provide a means of determining the following changes in the carbon brick specimen and the test media:

1.1.1 Weight, appearance, and compressive strength of the carbon brick specimen.

1.1.2 Appearance of the test media before, during, and after testing of the carbon brick specimen.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Ключевые слова:
alkali resistant; block; brick; carbon brick; chemical-resistant; conductive; fluoride resistant; tile