(812) 309-78-59
(495) 223-46-76
ASTM D4474-00
Standard Classification System for Styrenic Thermoplastic Elastomer Injection Molding and Extrusion Materials (TES) (Withdrawn 2008)
5 стр.
Отменен
Печатное изданиеЭлектронный (pdf)
93.60 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
83.060 Rubber / Резина
Сборник (ASTM):
08.02 Plastics (II): D3222–D5083 / Пластмасса (II): D3222–D5083
Тематика:
Plastics
Описание
Причина отмены

Formerly under the jurisdiction of Committee D20 on Plastics, this classification was withdrawn in April 2008 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

Область применения

1.1 This classification and subsequent line callout (specification) cover styrenic block copolymer thermoplastic elastomer materials for injection molding and extrusion. Copolymers consist of polystyrene segments bound to rubbery segments. The rubbery segments may be saturated or unsaturated. Compounding ingredients may be present as necessary for the application. The compounding ingredients may consist of reinforcements, resins, plasticizers, fillers, stabilizers, and colorants. Recycled styrenic thermoplastic elastomers are not covered in this classification.

1.2 The properties included in this classification are those required to identify the compositions covered. There may be other requirements necessary to identify particular characteristics that are important to specialized applications. These may be described by using the suffixes specified in Section 5.

1.3 The values stated in SI units, as detailed in IEEE/ASTM SI 10, are to be regarded as the standard.

Note 1--There is no equivalent ISO standard.

Ключевые слова:
line callout; plastic; styrenic; thermoplastic elastomer