(812) 309-78-59
(495) 223-46-76
ÖNORM EN 744:1995-10
Plastics piping and ducting systems - Thermoplastics pipes - Test method for resistance to external blows by the round-the-clock method
Заменен
Печатная копияПечатное издание
102.60 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
23.040.20 Plastics pipes / Пластмассовые трубы
Описание
This standard specifies a method for determining the resistance to external
blows of thermoplastics pipes with circular Cross sections by using the
round-the-clock method.
The method is intended to be applied to isolated batches of pipe. For type
testing and audit testing, 0 *C and/or -20 O C are applicable.
NOTE: Pipes made f rom polypropyl ene homopolymer (PP- W) whi ch
principally can not confonn to impact requirements at 0 C or lower
temperatures are permitted to be tested at (23 j: 2) OC under the
condition that PP-H pipes are intended for use for soil and waste
discharge and bear an additional marking indicating that they are not
to be installed below +5 OC.
Diese ÖNORM legt ein Verfahren zur Bestimmung der Widerstandsfähigkeit von Rohren aus thermoplastischen Kunststoffen mit kreisförmigem Querschnitt gegen äußere Schlagbeanspruchung im Umfangsverfahren (round-the-clock method) fest. Beschrieben werden das Verfahren, die Prüfgeräte, die Herstellung, Formgebung und Anzahl der Probekörper sowie ihre Vorbehandlung und die Durchführung des Verfahrens. Weiters sind Anleitungen über die Auswertung der Prüfergebnisse sowie über die in den Prüfbericht aufzunehmenden Angaben enthalten. Ein informativer Anhang enthält Anleitungen zur Entnahme von Proben aus der kontinuierlichen Rohrproduktion.
Ключевые слова:
Bauwesen,Rohr,Rohrleitung,Kunststoffrohr,Rohrleitungssystem,Schutzrohr,Thermoplast,Prüfung,Prüfverfahren,Widerstandsfähigkeit,Schlagbeständigkeit,Schlagbeanspruchung,Begriffe,Terminologie,Abmessung,Abbildung,Prüfgerät,Prüfbericht,Probekörper