(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 15526-2:2004-10
Plastics - Polyketone (PK) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties (ISO 15526-2:2000)
Действует
Печатная копияПечатное издание
79.20 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
83.080.20 Thermoplastic materials / Термопластические материалы
Описание
This part of ISO 15526 specifies the methods of preparation of test specimens and the test methods to be used in
determining the properties of polyketone moulding and extrusion materials. Requirements for handling test material
and for conditioning both the test material before moulding and the specimens before testing are given here.
Procedures and conditions for the preparation of test specimens and procedures for measuring properties of the
materials from which these specimens are made are given. Properties and test methods which are suitable and
necessary to characterize polyketone moulding and extrusion materials are listed.
The properties have been selected from the general test methods in, ISO 10350:1993. Other test methods in wide
use for or of particular significance to these moulding and extrusion materials are also included in this part of
ISO 15526, as are the designatory properties specified in part 1.
In order to obtain reproducible and comparable test results, it is necessary to use the methods of preparation and
conditioning, the specimen dimensions and the test procedures specified herein. Values determined will not necessarily
be identical to those obtained using specimens of different dimensions or prepared using different procedures.
Dieser Teil von ISO 15526 legt ein Verfahren zur Herstellung von Probekörpern und die anzuwendenden Prüfverfahren zur Bestimmung der Eigenschaften von Polyketon-Formmassen fest. Die Anforderungen hinsichtlich der Handhabung der untersuchten Formmasse und hinsichtlich der Konditionierung der Formmasse vor der Formgebung und der Probekörper vor dem Prüfen werden ebenfalls angegeben. Die Norm gibt die Verfahrensweise und die Bedingungen zur Herstellung von Probekörpern sowie die Verfahren zum Messen der Eigenschaften der Formmasse, aus der die Probekörper hergestellt wurden, vor. Des Weiteren erfolgt die Angabe der Eigenschaften und Prüfverfahren, die zur Charakterisierung von Polyketon-Formmassen geeignet und notwendig sind.
Ключевые слова:
Formmasse, Kunststoff, Extrusion, Prüfkörpervorbereitung, Prüfkörperherstellung, Prüfung, Materialprüfung, PK, Polyketone, Probekörper, Probekörperherstellung, Eigenschaft, Tabelle