(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 6145-7:2019-06
Gas analysis - Preparation of calibration gas mixtures using dynamic methods - Part 7: Thermal mass-flow controllers (ISO 6145-7:2018)
Действует
Печатная копияПечатное издание
150.53 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
71.040.40 Chemical. Including analysis of gases and surface chemical analysis / Химический анализ. Включая анализ газов
Описание
ISO 6145 is a series of documents dealing with various dynamic methods used for the preparation of calibration gas mixtures. This document specifies a method for continuous preparation of calibration gas mixtures, from nominally pure gases or gas mixtures by use of thermal mass-flow controllers. The method is applicable to preparation of mixtures of non-reacting species, i.e. those which do not react with any material of construction of the flow path in the thermal mass-flow controller or the ancillary equipment.
If this method is employed for preparation of calibration gas mixtures the optimum performance is as follows: the relative expanded measurement uncertainty U, obtained by multiplying the standard uncertainty by a coverage factor k = 2, is not greater than 2 %.
If pre-mixed gases are used instead of pure gases, mole fractions below 10-6 can be obtained. The measurement of mass flow is not absolute and the flow controller requires independent calibration.
The merits of the method are that a large quantity of the calibration gas mixture can be prepared on a continuous basis and that multi-component mixtures can be prepared as readily as binary mixtures if the appropriate number of thermal mass-flow controllers is utilized.
ISO 6145 ist eine Reihe von Dokumenten, die verschiedene dynamische Verfahren zur Herstellung von Kalibriergasgemischen behandeln. Dieses Dokument legt ein Verfahren zur kontinuierlichen Herstellung von Kalibriergasgemischen aus nominell reinen Gasen oder Gasgemischen mithilfe thermischer Massendurchflussregler fest. Das Verfahren wird zur Herstellung von Gemischen aus nicht reagierenden Gasspezies verwendet, d. h. solcher, die nicht mit den Materialien, die zur Ausführung des Durchflussweges im thermischen Massendurchflussregler oder der Zusatzausrüstung verwendet wurden, reagieren.
Wird dieses Verfahren zur Herstellung von Kalibriergasgemischen angewendet, ist die optimale Leistung wie folgt: die relative erweiterte Messunsicherheit U, die durch Multiplizieren der Standardunsicherheit mit einem Überdeckungsfaktor von k = 2 erhalten wird, ist nicht größer als 2 %.
Werden anstelle reiner Gase Gasvorgemische verwendet, können Molfraktionen unter 10¿6 erreicht werden. Die Messung des Massenstroms ist nicht absolut und für den Massendurchflussregler ist eine unabhängige Kalibrierung erforderlich.
Die Vorzüge dieses Verfahrens bestehen darin, dass eine große Menge des Kalibriergasgemisches kontinuierlich hergestellt werden kann und dass Mehrkomponentengemische bei entsprechender Anzahl von thermischen Massestromreglern so einfach wie binäre Gemische hergestellt werden können.
Ключевые слова:
volumetrische Analyse, Kontrollprobe, Gasgemisch, Massendurchfluss, Vorbereitung, thermisch, Probenvorbehandlung, Prüfgas, Mündung, Herstellung, Kalibriergas, gasvolumetrische Analyse, Gasanalyse, Durchflussregler, Durchfluss, Berechnung, Öse