(812) 309-78-59
(495) 223-46-76
ÖNORM EN ISO 75-2:2006-09
Plastics - Determination of temperature of deflection under load - Part 2: Plastics and ebonite (ISO 75-2:2004) (consolidated version)
Заменен
Печатная копияПечатное издание
81.60 € (включая НДС 20%)
Разработчик:
Зарубежные/ON
ICS:
83.060 Rubber / Резина83.080.01 Plastics in general / Пластмассы в целом
Описание
This part of ISO 75 specifies three methods, using different values of constant flexural stress, that can be used for
the determination of the temperature of deflection under load of plastics (including filled plastics and fibrereinforced
plastics in which the fibre length, prior to processing, is up to 7,5 mm) and ebonite:
method A, using a flexural stress of 1,80 MPa;
method B, using a flexural stress of 0,45 MPa;
method C, using a flexural stress of 8,00 MPa.
The standard deflection Δs used to determine the temperature of deflection under load corresponds to a flexuralstrain
increase defined in this part of ISO 75. The initial flexural strain due to the loading of the specimen at
room temperature is neither specified nor measured in this part of ISO 75. The ratio of this flexural-strain difference
to the initial flexural strain depends on the modulus of elasticity, at room temperature, of the material under test.
This method is therefore only suitable for comparing the temperatures of deflection of materials with similar roomtemperature
elastic properties.
NOTE The methods give better reproducibility with amorphous plastics than with semi-crystalline ones. With some
materials, it may be necessary to anneal the test specimens to obtain reliable results. Annealing procedures, if used, generally
result in an increase in the temperature of deflection under load (see 6.6).
For additional information, see ISO 75-1:2004, clause 1.
Dieser Teil von ISO 75 legt 3 Verfahren fest zur Bestimmung der Wärmeformbeständigkeitstemperatur von Kunststoffen (einschließlich von gefüllten Kunststoffen und langfaserverstärkten Kunststoffen, bei denen die Faserlänge vor der Verarbeitung bis zu 7,5 mm beträgt) und Hartgummi unter Verwendung verschiedener Biegespannungen: - Verfahren A, unter Verwendung einer Biegespannung von 1,80 MPa; - Verfahren B, unter Verwendung einer Biegespannung von 0,45 MPa; - Verfahren C, unter Verwendung einer Biegespannung von 8,00 MPa. Diese ÖNORM enthält die Europäische Berichtigung AC:2006, mit der der deutsche Titel modifiziert wurde.
Ключевые слова:
Bestimmung,Wärmeformbeständigkeit,Temperatur,Prüfkörper,Kunststoff,Bestimmungsverfahren,wärmeformbeständig,Prüfung,Prüfverfahren,Hochtemperatur,Biegeprüfung,Prüfgerät,Biegespannung,Prüfeinrichtung,Berechnung,Prüfbericht,Formbeständigkeit,Abmessung,Auswertung,Hartgummi,Prüfkörpervorbereitung,Faserverstärkung,Materialprüfung,Wärmebeständigkeit,Wärmebeständigkeitsprüfung