(812) 309-78-59
(495) 223-46-76
ASTM B194-15
Standard Specification for Copper-Beryllium Alloy Plate, Sheet, Strip, and Rolled Bar
11 стр.
Заменен
Электронный (pdf)Печатное издание
112.32 $ (включая НДС 20%)
Разработчик:
Зарубежные/ASTM
ICS:
77.150.30 Copper products / Продукция из меди
Сборник (ASTM):
02.01 Copper and Copper Alloys / Медь и сплавы из меди
Тематика:
Copper
Описание
Значение и использованиеA1.3 Significance and Use

A1.3.1 These test methods are primarily intended to test for compliance with composition specifications. It is assumed that all who use these test methods will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory.

Реферат

This specification establishes the requirements for plates, sheets, strips, and rolled bars of copper-beryllium alloy with Copper Alloy UNS Nos. C17000 and C17200. Materials shall be processed by the following conditions: solution heat treatment, solution heat treatment and cold working, precipitation heat treatment, and mill hardening. Specimens shall adhere to specified chemical composition, grain size, and grain count requirements. Alloys shall also undergo tensile and bend tests to evaluate their conformance to tensile strength, yield strength, elongation, and Rockwell hardness requirements.

Область применения

1.1 This specification establishes the requirements for copper-beryllium alloy plate, sheet, strip, and rolled bar. The following alloys are specified:2

Copper Alloy

Previously Used Commercial

Nominal Beryllium

UNS No.2

Designations

Content, %

C17000

Alloy 165

1.7

C17200

Alloy  25

1.9

1.2 Unless otherwise specified in the contract or purchase order, Copper Alloy UNS No. C17200 shall be the alloy furnished.

1.3 Units—Values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following safety hazard caveat pertains only to the test method(s) described in the annex of this specification:

1.4.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

Ключевые слова:
C17000; C17200; copper-beryllium; flat products; copper plate; copper rolled bar; copper strip ;