The true specific gravity of a material is the ratio of its true density, determined at a specific temperature, to the true density of water, determined at a specific temperature. Thus, the true specific gravity of a material is a primary property which is related to chemical and mineralogical composition.
This test method is particularly useful for hydratable materials which are not suitable for test with Test Method C 135
For refractory raw materials and products the true specific gravity is a useful value for: classification, detecting differences in chemical composition between supposedly like samples, indicating mineralogical phases or phase changes, calculating total porosity when the bulk density is known, and for any other test method that requires this value for the calculation of results.
This test method is a primary standard method which is suitable for use in specifications, quality control, and research and development. It can also serve as a referee test method in purchasing contracts or agreements.
Fundamental assumptions inherent in this test method are the following:
The sample is representative of the material in general,
The total sample has been reduced to the particle size specified,
No contamination has been introduced during processing of the sample,
The ignition of the sample has eliminated all free or combined water without inducing sintering or alteration,
An inert gas (helium) has been used in the test, and
The test method has been conducted in a meticulous manner.
Deviation from any of these assumptions negates the usefulness of the results.
In interpreting the results of this test method it must be recognized that the specified sample particle size is significantly finer than specified for Test Method C 135
1.1 This test method covers the determination of the true specific gravity of solid materials, and is particularly useful for materials that easily hydrate which are not suitable for test with Test Method C 135
1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1 Exception—In 7.3 the equivalent SI unit is expressed in parenthesis.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.