Formerly under the jurisdiction of Committee D18 on Soil and Rock, this specification was withdrawn in January 2024 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
РефератThis specification covers the quality and grading of the following materials for use in the construction of subbase, base, and surface courses: sand-clay mixtures; gravel; stone or slag screenings; sand; crusher-run coarse aggregate consisting of gravel, crushed stone, or slag combined with soil mortar; or any combination of these materials. The requirements are intended to cover materials having normal specific gravity, absorption, and gradation characteristics. Where other materials are to be used, appropriate limits suitable to their use must be specified. The material shall be classified into two types namely Type I and Type II. Type I mixtures shall consist of stone, gravel, or slag with natural or crushed sand and fine mineral particles passing a No. 200 sieve and shall conform to the requirements specified for Gradation A, B, C, or D. On the other hand, Type II mixtures shall consist of natural or crushed sand with fine mineral particles passing a No. 200 sieve, with or without stone, gravel, or slag, and shall conform to the requirements specified for Gradation E or F. Different tests shall be conducted in order to determine the following properties of the aggregates: abrasion loss, liquid limit, plastic limit, and plasticity index.
Область применения1.1 This specification covers the quality and grading of the following materials for use in the construction of subbase, base, and surface courses: sand-clay mixtures; gravel; stone or slag screenings; sand; crusher-run coarse aggregate consisting of gravel, crushed stone, or slag combined with soil mortar; or any combination of these materials. The requirements are intended to cover materials having normal specific gravity, absorption, and gradation characteristics. Where other materials are to be used, appropriate limits suitable to their use must be specified.
1.2 Units—The values stated in SI units are to be regarded as standard. The sieve designations are identified using the “standard” system in accordance with Specification E11, such as 25-mm and 75-µm, followed by the “alternative” system of 1-in. and No. 200, respectively. Use of the “alternative” system shall not be regarded as nonconformance with this standard.
1.3 The following precautionary caveat pertains only to the Test Methods portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.