4.1 The procedures described in this practice are intended to be used to establish appropriate allowable unit stresses, moduli of elasticity, and specific gravity for mechanically graded solid sawn lumber. An on-going quality control program to monitor compliance with the assigned grade properties is required.

1.1 This practice covers the methodology of grade qualification, assignment of design properties, and requirements for the quality control of mechanically graded solid sawn lumber.

1.2 This practice acknowledges alternative methods for the assignment of specific properties. These methods are assignment by test, relationship to other properties, and by procedures in other appropriate standards.

1.3 The values stated in inch-pound units are to be regarded as standard. When there are values given in parentheses, these are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.