Причина отмены This specification covers composite corrugated steel pipe, intended for uses such as storm water drainage, sanitary sewers, underdrains, construction of culverts, and similar uses. The composite material used in fabrication of the pipe consists of a three-layer polymer protective coating on both sides of a steel sheet core. The three layers consist of an inner layer of fusion-bonded epoxy on the steel surface, an intermediate layer of polyethylene adhesive, and an outer layer of high-density polyethylene.

Formerly under the jurisdiction of Committee A05 on Metallic-Coated Iron and Steel Products, this specification was withdrawn in May 2015. This standard is being withdrawn without replacement due to its limited use by industry.

Реферат

This specification covers composite corrugated steel pipe, intended for uses such as storm water drainage, sanitary sewers, underdrains, construction of culverts, and similar uses. The composite material used in fabrication of the pipe consists of a three-layer polymer protective coating on both sides of a steel sheet core. The composite corrugated steel pipe covered by this specification is classified as Type IC and Type ICS. Type IC pipe shall be fabricated with helical corrugations and a continuous lock seam extending helically from end to end of each length of pipe. Type ICS shall be fabricated with helical corrugations and a continuous helical lock seam extending from end to end of each length of pipe, and with a smooth high-density polyethylene liner thermally bonded to the pipe polymer coating at each interior corrugation crest over the length of the pipe. Types IC and ICS pipe shall conform to the pipe dimensions and sheet thickness. Field joints for each type of composite corrugated steel pipe shall maintain pipe alignment during construction and prevent infiltration of fill material during the life of the installation. The following types of coupling systems shall be permitted: flange type; bell and spigot type; band type with annular corrugations; flat band type; and smooth sleeve type. Specimens cut from production pipe normal to and across the lock seam shall develop the specified tensile strength.

Область применения

1.1 This specification covers composite corrugated steel pipe, intended for uses such as storm water drainage, sanitary sewers, underdrains, construction of culverts, and similar uses. The composite material used in fabrication of the pipe consists of a three-layer polymer protective coating on both sides of a steel sheet core. The three layers consist of an inner layer of fusion-bonded epoxy on the steel surface, an intermediate layer of polyethylene adhesive, and an outer layer of high-density polyethylene.

1.2 The three-layer polymer coating protects the base metal against corrosion or abrasion, or both. Severe environments are likely to cause corrosion problems to accessory items such as coupling band hardware unless supplemental protection is provided. Additional protection for composite steel pipe is available by use of coatings applied after fabrication of the pipe as described in Specification A849.

1.3 This specification does not include requirements for bedding, backfill, or the relationship between earth cover load and sheet thickness of the pipe. Experience with drainage products has shown that successful performance depends upon the proper selection of corrugation profile, sheet thickness, type of bedding and backfill, controlled manufacture in the plant, and care in installation. The installation procedure is described in Practice A798/A798M.

1.4 This specification is applicable to orders in either inch-pound units as A1042, or in SI units as A1042M. Inch-pound units and SI units are not necessarily equivalent. SI units are shown in brackets in the text for clarity, but they are the applicable values when the material is ordered to A1042M.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.