Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ASTM A74-04

Заменен
Standard Specification for Cast Iron Soil Pipe and Fittings — 44 стр.
Область применения

1.1 This specification covers cast iron soil pipe and fittings for use in gravity flow plumbing, drain, waste and vent sanitary and storm water applications. It establishes standards covering material, manufacture, mechanical and chemical properties, coating, test methods, inspection, certification, product markings, dimensions, and dimensional tolerances for extra heavy and service cast iron soil pipe and fittings. These pipe and fittings are not intended for pressure applications as the selection of the proper size for sanitary drain, waste, vent, and storm drain systems allows free air space for gravity drainage.

1.2 This specification covers pipe and fittings of the following patterns and, when so designated, shall apply to any other patterns that conform with the applicable requirements given herein.

1.2.1 Pipe

TablesExtra heavy, 2½ ft (0.75 m), 3½ ft (1.0 m), 5 ft (1.5 m), 10 ft (3.0 m) lengths 1, 2 Service, 2½ ft (0.75 m), 3½ ft (1.0 m), 5 ft (1.5 m), 10 ft (3.0 m) 1, 2 Outside dimensions (for detailing)X1.1

1.2.2 Fittings

Tables1/4 bends; long 1/4 bends 3, 41/4 bends, long low-hub 51/4 bends, low heel; high heel6, 71/4 bends, short sweep; long sweep81/4 bends, reducing long sweep91/5 bends101/6 bends101/8 bends; long 1/8 bends111/16 bends 11Y branches12, 13Y branches, cleanout on main 14Y branches, cleanout on branch15Y branches, inverted16Y branches, combination 1/8 bends, single17Y branches, combination 1/8 bends, double17Y branches, combination 1/8 bends, cleanout18Y branches, upright 19Sanitary T branches, single 20Sanitary T branches, double20Sanitary T branches, cleanout21Tapped sanitary T branches, single22Tapped sanitary T branches, double22T branches, single and double23Tapped T branches, single 24Tapped T branches, double 24Horizontal twin tapped T25T branches, cleanout 26Vent branches, single 27Offsets, 1/8 bend 28Double hubs 29Long double hubs29Reducers 30Increasers 31, 32S traps 33P traps 34, 35Deep seal P traps 36Running traps 37Screw plugs (brass) 38Blind plugs 39Iron-body ferrules 40Side inlets Fig. 3Closet bends 41Tapping bosses 42Hubbed Cleanout Cap43

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. Metric conversions in Table 1 and Table 2 are to two decimal places; all other metric conversions are rounded to the nearest whole number.

ICS
23.040.40 Metal fittings / Металлические фитинги
Сборник ASTM
01.02 Ferrous Castings; Ferroalloys / Стальное литье, Ферросплавы
Тематика
Ferroalloys, Castings