This specification covers a group of common requirements that, unless covered by the individual product specification in another ASTM document, applies to steel and alloy castings for use in general industrial applications. Materials shall be produced by open-hearth or electric furnace process with or without separate refining, such as argon-oxygen-decarburization (AOD), and then consequently heat treated in the working zone. Castings shall receive heat and product analysis to evaluate their conformance to chemical composition requirements. Mechanical requirements shall also be assessed. The surfaces of castings shall be free of adhering sand, scale, cracks, hot tears, and other surface discontinuities. Repair welding may be performed as required.

1.1 This specification covers a group of requirements that are mandatory requirements of the following steel casting specifications issued by ASTM. If the product specification specifies different requirements, the product specification shall prevail.

ASTM
Designation

 
Title of Specification

A27/A27M

Steel Castings, Carbon, for General Application

A128/A128M

Steel Castings, Austenitic Manganese

A148/A148M

Steel Castings, High Strength, for Structural Purposes

A297/A297M

Steel Castings, Iron-Chromium and Iron-Chromium-Nickel, Heat Resistant, for General Application

A447/A447M

Steel Castings, Chromium-Nickel-Iron Alloy (25-12 Class), for High-Temperature Service

A494/A494M

Castings, Nickel and Nickel Alloy

A560/A560M

Castings, Chromium-Nickel Alloy

A743/A743M

Castings, Iron-Chromium, Iron-Chromium-Nickel, Corrosion Resistant, for General Application

A744/A744M

Castings, Iron-Chromium-Nickel, Corrosion Resistant, for Severe Service

A747/A747M

Steel Castings, Stainless, Precipitation Hardening

A890/A890M

Castings, Iron-Chromium-Nickel-Molybdenum Corrosion-Resistant, Duplex (Austenitic/Ferritic) for General Application

A915/A915M

Steel Castings, Carbon and Alloy, Chemical Requirements Similar to Standard Wrought Grades

A958/A958M

Steel Castings, Carbon and Alloy, with Tensile Requirements, Chemical Requirements Similiar to Standard Wrought Grades

A1002

Castings, Nickel-Aluminum Ordered Alloy

1.2 This specification also covers a group of supplementary requirements that may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.

1.3 The requirements of the individual material specification and this general specification shall prevail in the sequence named.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.