This specification covers epoxy-coated steel wires, in coils, for general use. The protective epoxy coatings covered here are available in three classes, namely: Class A, which are intended for use in moderate corrosion protection; Class B, which are intended for more severe protection; and Class C, which are intended for severe corrosion and abrasion protection. Prior to cleaning and coating, the steel wires shall be free of surface contaminants such as oil, grease, or paint. Wire surfaces shall be cleaned by abrasive cleaning or chemical cleaning to ensure proper adherence of the epoxy. Coatings shall then be applied as soon as possible after cleaning, before possible oxidation, and shall be properly cured. Wrap, bend and tensile tests shall be performed in order to evaluate coating properties, including thickness, continuity, adherence, size tolerance, and tensile strength.

1.1 This specification covers steel wire in the size range of 0.120 to 0.500 in. (3.05 to 12.7 mm) with three classes of protective epoxy coating, in coils, for general use. Class A coating is intended for use for moderate corrosion protection, Class B coating for more severe protection, and Class C for severe corrosion and abrasion protection.

Note 1: The coating applicator is identified throughout this specification as the manufacturer.

1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.