This specification covers the standard for aluminum-alloy drawn seamless round tube in straight lengths proposed for use in surface condensers, evaporators, and heat exchangers. The tubes shall be manufactured by drawing an extruded tube made from hollow extrusion ingot and extruded using the die and mandrel method. Tubes shall conform to specified chemical composition requirements.
Область применения1.1 This specification covers aluminum-alloy (Note 1) drawn seamless round tube in straight lengths designated as shown in Table 2, for use in surface condensers, evaporators, and heat exchangers. Note 1 Throughout this specification use of the term alloy in the general sense includes aluminum as well as aluminum alloy.
Note 2For drawn seamless tubes used in general applications, see Specification B 210; for extruded tubes see Specification B 221; for seamless pipe see Specification B 241/B 241M; and for structural pipe and tube see Specification B 429.
1.2 Alloy and temper designations are in accordance with ANSI H35.1. The equivalent Unified Numbering System alloy designations are those of preceded by A9, for example, A91060 for aluminum 1060, in accordance with Practice E 527.
1.3 A complete metric companion to Specification B 234 has been developed-B 234M; therefore, no metric equivalents are presented in this specification.
1.4 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see .
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.