This specification establishes the requirements for phosphorized copper in refinery shapes such as wire bars, billets, and cakes. The product furnished shall be produced from one of the following copper UNS Nos.: C10300, C10800, C12000, C12200, and C14200. Billets shall be supplied sheared on one end with the other end flat or with both ends flat depending on the specified diameter. The product shall conform to the chemical composition requirements prescribed for copper and silver, phosphorus, and arsenic. The electrical mass resistivity for phosphorized copper in annealed condition is specified. The requirements for chemical analysis, reverse bend test (hydrogen embrittlement susceptibility), and microscopical examination are detailed including sampling and specimen preparation.

1.1 This specification establishes the requirements for phosphorized copper wire bars, billets, and cakes.

Note 1—Wire bars furnished under this specification do not conform in dimensions with that furnished under Specification B 5.

1.2 The values in inch-pound units are the standard. SI values given in parentheses are for information only.

1.3 The following hazard caveat applies to of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.