Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ASTM B476-01(2017)

Заменен
Standard Specification for General Requirements for Wrought Precious Metal Electrical Contact Materials — 4 стр.
Значение и использование

11.1 For purpose of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value or a calculated value shall be rounded as indicated in accordance with Practice E29.

Property

Unit

Rounded Unit
for Observed or
Calculated Value

Chemical composition

percent

 

Hardness
Knoop (100-g load unless other-
  wise specified)
Vicker (specify load)
Rockwell (all scales, specify which)
Rockwell superficial (all scales,
  specify which)

 

nearest unit on the last right
 hand place of figure of
 specified limit

 Resistivity

 μΩ·cm

 

 Tensile strength

 psi (MPa)

nearest 1000 psi (nearest 10
 MPa)

 Yield Strength

 psi (MPa)

nearest 1000 psi (nearest
 10 MPa)

Elongation

 

 

 Below 5 %

 percent

nearest multiple of 0.5 %

 5 % and over

 percent

nearest 1 %

Grain size

 

 

 Up to 0.055 mm  incl.

 mm

nearest multiple of  0.005
 mm

 Over 0.055 to 0.160, mm, incl.

 mm

nearest 0.01 mm

Реферат

This specification covers general requirements common to wrought precious metal electrical contact alloy products in the form of sheet, strip, wire, and rod. The raw material shall be of such quality and purity that the finished product shall have the properties and characteristics prescribed in the applicable product specification. The product shall be produced by a combination of hot or cold working operations, it shall be finished, unless otherwise specified, by cold working, annealing, or heat treatment as may be necessary to meet the specified properties. Surfaces of all material furnished to this specification shall be smooth, clean, and free from scratches, stains, rough spots, slivers, laps, scale, pits, and any other injurious defects. Test methods such as chemical analysis and physical tests shall be performed accordingly.

Область применения

1.1 This specification covers general requirements common to wrought precious metal electrical contact alloy products in the form of sheet, strip, wire, and rod. Unless otherwise specified in the purchase order or in an individual specification, these general requirements shall apply to wrought electrical contact materials where indicated in the applicable product specifications issued by ASTM.

1.2 In case of conflict, the requirements on the purchase order, the individual specification, and this general specification shall prevail in the sequence named.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ICS
77.120.99 Other non-ferrous metals and their alloys / Цветные металлы и их сплавы прочие
Сборник ASTM
02.04 Nonferrous Metals – Nickel, Titanium, Lead, Tin, Zinc, Zirconium, Precious, Reactive, Refractory Metals and Alloys: Materials for Thermostats, Electrical Heating and Resistance Contact, and Connectors / Цветные металлы - Никель, Кобальт, Свинец, Олово, Цинк, Кадмий, Драгоценные металлы, химически активные металлы, Тугоплавкие металлы и сплавы, Материалы для Термостатов, Электронагревательных приборов, Контактов, Соединительные устройств
Тематика
Other Nonferrous Metals